Model |
WNRT-300
|
Hardware Specification |
Interface |
LAN / WAN : 1 x 10/100Mbps Auto MDI/MDI-X RJ45 port |
Antenna |
Gain: 1 x Internal 2dBi Antenna
Orientation: Omni-directional |
Button / Switch |
Front panel (from left to right):
- Mode Selection Switch (Router / Client / AP)
- WPS Button
- Power On / Off Switch
Rear panel:
- Reset button
* Push for above 5 seconds to reset to factory default settings |
LED Indicators |
PWR, WLAN, WAN/LAN, WPS, CHG |
Material |
Plastic |
Dimension (W x D x H) |
88 x 62 x 18 mm |
Weight |
With battery: 80g
Without battery: 58g |
Battery |
Built-in Rechargeable Li-ion Battery (3.7V, 1050mAh) |
Power Requirement |
DC 5V , 0.4A maximum, connected through mini-USB connector |
Power Adapter |
AC Input: 100~240V AC (50/60Hz)
DC Output: 5V with max. 1A current |
Standard Accessory |
Power Adapter x 1, USB Cable x 1, Ethernet Cable x 1, Li-ion Battery x 1, CD-ROM x 1, Quick Guide x 1 |
Wireless Interface Specification |
Standard |
Compliance with IEEE 802.11b/g/n |
Frequency Band |
2.4 ~ 2.4835GHz |
Extend Frequency |
DSSS |
Modulation Type |
DBPSK, DQPSK, QPSK, CCK and OFDM (BPSK / QPSK / 16-QAM / 64-QAM) |
Data Transmission Rates |
11n: Up to 150Mbps (Dynamic)
11g: Up to 54Mbps (Dynamic)
11b: Up to 11Mbps (Dynamic) |
Transmission Distance |
Indoor up to 100m
Outdoor up to 300m (Depends on the environment conditions) |
Channel |
America/ FCC: 2.412 ~ 2.462GHz (11 Channels)
Europe/ ETSI: 2.412 ~ 2.472GHz (13 Channels)
Japan/ TELEC: 2.412 ~ 2.484GHz (14 Channels) |
Max. RF Power |
20 dBm (EIRP) |
Receive Sensitivity |
135M: -68dBm@10% PER
54M: -68dBm@10% PER
11M: -85dBm@8% PER |
Software Features |
Operation Mode |
■ AP
■ Router
■ Client
(Switchable by hardware) |
Wireless Mode |
AP, WDS, Repeater (WDS+AP), Universal Repeater (AP + Client) |
Encryption Security |
WEP (64/128-bit) encryption security
WPA-Enterprise / WPA2-Enterprise (TKIP/AES)
WPA-Personal / WPA2-Personal (TKIP/AES)
802.1x Authentication |
Wireless Security |
Provides wireless LAN ACL (Access Control List) filtering
Wireless MAC address filtering
Supports WPS (Wi-Fi Protected Setup)
Multiple SSID up to 5 wireless groups, each mapped to a separate 802.1p/q tagged VLAN
Enable / Disable SSID Broadcast |
Wireless Advanced |
WMM (Wi-Fi Multimedia): 802.11e Wireless QoS
IAPP (Inter Access Point Protocol): 802.11f Wireless Roaming
Provides Wireless Statistics |
Internet Connection Type |
Shares data and Internet access by supporting the following types of internet access:
- PPPoE
- Dynamic IP
- Static IP
- PPTP
- L2TP |
Firewall |
NAT firewall with SPI (Stateful Packet Inspection)
Built-in NAT server supporting Port Forwarding, and DMZ
Built-in firewall with IP address/ MAC address/ Port/ URL filtering
Supports ICMP-FLOOD, UDP-FLOOD, TCP-SYN-FLOOD filter, and DoS protection
Supports 802.1Q VLAN up to 4 |
Routing Protocol |
Static / Dynamic (RIP1 and 2) Routing |
VPN Pass-through |
PPTP, L2TP, IPSec, IPv6 |
LAN |
Built-in DHCP server supporting static IP address distributing
Supports UPnP, Dynamic DNS
Supports IGMP Proxy
Supports 802.1d STP (Spanning Tree)
IP / MAC-based Bandwidth Control |
System Management |
Web-Based (HTTP) management interface
SNTP time synchronize
Easy firmware upgrade
System Log supports Remote Log |
Standards Conformance |
IEEE Standards |
IEEE 802.11n (1T1R, up to 150Mbps)
IEEE 802.11g
IEEE 802.11b
IEEE 802.11i
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3x Flow Control |
Other Protocols and Standards |
CSMA/CA, CSMA/CD, TCP/IP, DHCP, ICMP, NAT, PPPoE, SNTP |
Environment |
Temperature |
Operating: 0 ~ 40 Degree C
Storage: -40 ~ 70 Degree C |
Humidity |
Operating: 10 ~ 90% (Non-Condensing)
Storage: 5 ~ 90% (Non-Condensing) |