| Model |
WGSW-2620HP
|
| Hardware Specification |
| 10/100Mbps Copper Ports |
24 10/100Base-TX RJ-45 Auto-MDI/MDI-X ports |
| 1000Mbps Copper Ports |
2 10/100/1000Mbps RJ-45 Auto-MDI/MDI-X ports |
| SFP/mini-GBIC Slots |
2 1000Base-SX/LX/BX, shared with Port-25 and Port-26 |
| Switch Architecture |
Store-and-Forward |
| Switch Fabric |
8.8Gbps / non-blocking |
| Switch Throughput |
6.547Mpps @64Bytes |
| Address Table |
8K entries |
| Share Data Buffer |
512Kbytes |
| Flash |
4MB |
| DRAM |
32MB |
| Maximum Frame Size |
9K Bytes |
| Flow Control |
Back pressure for Half-Duplex
IEEE 802.3x Pause Frame for Full-Duplex |
| LED |
Power, PoE Power, FAN Alert
Link / Activity (Green)
PoE In-Use (Amber)
1000 LNK / ACT (Green)
10/100 LNK / ACT (Green) |
| Dimension ( W x D x H) |
440 x 300 x 44.5 mm, 1U height |
| Weight |
4.6kg |
| Power Requirement |
100 - 240VAC, 50 - 60Hz, Auto-sensing |
| Power Consumption |
System
‧110V: 29 Watts / 98BTU
‧220V: 31 Watts / 105BTU
Ethernet Full Loading
‧110V: 34 Watts / 116BTU
‧220V: 35 Watts / 119BTU
PoE Full Loading
‧110V: 360 Watts / 1228BTU
‧220V: 360 Watts / 1228BTU |
| Reset Button |
< 5 sec: System reboot
> 10 sec: Factory Default |
| Power over Ethernet |
| PoE Standard |
IEEE 802.3af / IEEE 802.3at Power over Ethernet / PSE |
| PoE Power Supply Type |
End-Span |
| PoE Power Output |
Per Port 52V DC, 350mA . Max.15.4 Watts (IEEE 802.3af)
Per Port 52V DC, 590mA. Max. 30 Watts (IEEE 802.3at) |
| Power Pin Assignment |
1/2(+), 3/6(-) |
| PoE Power Budget |
360 Watts (Port 1 to port 12: 180 Watts, port 13 to port 24: 180 Watts) |
| Max. number of Class 1 PD |
24 |
| Max. number of Class 2 PD |
24 |
| Max. number of Class 3 PD |
24 |
| Max. number of Class 0, 4 PD |
11 |
| Layer 2 Function |
| Management Interface |
Console, Telnet, Web Browser, SSL, SNMPv1, v2c, v3 |
| Port Configuration |
Port disable / enable
Auto-Negotiation
10/100/1000Mbps full and half duplex mode selection
Flow Control disable / enable |
| Port Status |
Display each port’s speed duplex mode, link status and Flow control status
Auto negotiation status, trunk status |
| Port Mirroring |
TX / RX / Both
1 to 1 monitor |
| Bandwidth Control |
Ingress / Egress Rate Control
‧ Allow to configure per 128Kbps |
| VLAN |
IEEE 802.1Q Tag-Based VLAN, up to 255 VLANs groups, out of 4041 VLAN IDs
Port-Based VLAN
Q-in-Q tunneling
GVRP for VLAN Management, up to 128 dynamic VLAN entries
Private VLAN Edge (PVE / Protected port) with two protected port groups |
| Link Aggregation |
Static Port Trunk
IEEE 802.3ad LACP (Link Aggregation Control Protocol)
Supports 13 groups of 8-Port trunk support |
| QoS |
4 priority queue
Traffic classification based on:
‧ Port priority
‧ 802.1p priority
‧ DSCP/TOS field in IP Packet |
| IGMP Snooping |
IGMP (v1/v2) Snooping, up to 256 multicast Groups |
| Access Control List |
IP-Based Layer 3 / Layer 4 ACL
Up to 200 ACL rule entries |
| SNMP MIBs |
RFC-1213 MIB-II
RFC-2863 Interface MIB
RFC-2665 EtherLike MIB
RFC-1493 Bridge MIB
RFC-2819 RMON MIB (Group 1, 2, 3,9)
RFC-2737 Entity MIB
POWER-ETHERNET-MIB |
| Standards Conformance |
| Standards Compliance |
IEEE 802.3:10Base-T
IEEE 802.3u:100Base-TX
IEEE 802.3z:1000Base-SX/LX
IEEE 802.3ab:1000Base-T
IEEE 802.3x:Flow Control and Back pressure
IEEE 802.3ad:Port trunk with LACP
IEEE 802.1D:Spanning Tree Protocol
IEEE 802.1s:Multiple Spanning Tree Protocol
IEEE 802.1p:Class of Service
IEEE 802.1Q:VLAN Tagging
IEEE 802.1x:Port Authentication Network Control
IEEE 802.3af:Power over Ethernet
IEEE 802.3at:Power over Ethernet
RFC 768:UDP
RFC 793:TFTP
RFC 791:IP
RFC 792:ICMP
RFC 2068:HTTP
RFC 1112:IGMP version 1
RFC 2236:IGMP version 2 |
| Environment |
| Operating Temperature |
0 ~ 50 Degree C |
| Operating Humidity |
10 ~ 95% (non-condensing) |
| Storage Temperature |
-20 ~ 70 Degree C |
| Storage Humidity |
10 ~ 95% (non-condensing) |
26248 грн * Гарантия 12 месяцев